Entries by Accu Tech

CO2 Laser Machining

What can you do with a CO2 laser? CO2 Laser Machining has been an essential tool for several industries since the 1980s. Early implementations were cutting holes and shaping the extremely hard electronics grade ceramics beginning to be used for circuit boards that required very high strength and good heat dissipation from the new high […]

Watch this Space!

Accu-Tech Laser Processing is transitioning to a new larger facility to accommodate our growth! We are moving just down the road and staying in San Marcos, California. Our new facility will give us room for more laser equipment to better serve our customers’ requirements. We expect the move to be complete in 30 days. There […]

Corona Virus Covid-19

Accu-Tech is keeping a close eye on the Covid-19 situation. We are following Federal and Health agency guidelines for the safety of our employees and community. We intend to stay open to serve our customers as we are an ESSENTIAL business serving our medical and defense sector customers. Bear with us, as this may cause […]

Accu-Tech adds a new laser marker

A new laser marker workstation is up and running at Accu-Tech Laser Processing. This adds to our capabilities for marking, as well as serializing parts for tracking or advertising. Check out our examples of parts with laser marking. Our laser will put permanent marks on your components, as a result, the laser engraving will not […]

Accu-Tech to install new Laser Workstation

Accu-Tech is in the final phase of integrating a new Laser Workstation into its Micro Via – Flex Panel department. This new laser tool will boost our capacity and add backup systems to better serve our quick turnaround circuit board customers. While this new workstation is already carrying its share of the load. It is […]